AGM Global Vision COBRA TB50-336, User Manual

Page: 19 / 32

19 Cobra
USER MANUAL
NOTE:
After configuration is complete, select EXIT on the MAIN MENU and push the OK button to leave
the MAIN MENU. All settings will be saved.
2.3 OPERATING PROCEDURES
2.3.1 OPERATING
CAUTION:
DO NOT force the equipment controls past their stopping points.
CAUTION:
To prevent thermal damage to the equipment, never point it, either powered or not, directly at the
sun or any other source of high intensity light that the unprotected human eye cannot tolerate
(such as a welding arc). To prevent inadvertent exposure to these sources, never leave the
equipment without the objective lens cap secured.
Operating procedures are as follows:
1. Remove the Cobra from the carrying case.
2. Remove the objective lens cap.
3. Point the equipment at an object.
4. Activate the Cobra by turning the operation switch ON. After approximately 3 sec, video of the
thermal scene should appear.
5. Adjust the Cobra for your eyesight by turning the eyepiece focus rings CW up to the stop, and
then CCW until the display and symbols are as clear as possible. Bring the object into focus by
turning the objective focus ring (CW for far focus, CCW for near focus).
NOTE:
The total diopter adjustment range is covered with 2 turns of the eyepiece focus ring.
The total focus range is covered with three quarter turns of the objective focus ring.
SETTINGS
> EXIT
RIFLE PROFILE < > 1
STANDARD < > NTSC
TEMP. UNITS < > F
LEFT MARGIN < > 60
RIGHT MARGIN < > 20
FACTORY DEFAULTS
FIGURE 2-15. SETTINGS MENU