Agilent Technologies TS-5410, Site Preparation And Installation Manual

Page: 25 / 30

Test System Installation 25 Chapter 2
lower rear of the test stand.
6. Plug-In the power cord to the power receptacle. Perform the
following procedure “PC and Peripheral Connections” before turning
on the system power switch.
PC and Peripheral Connections
For your convenience, PC connections have been brought out to the rear of
the system on the PC and GPIB Connector Panel (Figure 2-5).
1. Connect the monitor, keyboard, mouse, LAN and any USB or serial
devices such as barcode readers and strip printers to this connector
panel. .
Figure 2-4. Filtered Power Strip/Cord Location
Connect Power
Cord Here
REAR
Mass Connect
Power Strip
DC Fan Assembly
Engenious Engenious
12V
DC
24V
DC