Agilent Technologies N9360A, Programming Manual

Page: 128 / 180

6-4 N9360A Multi UE Tester W-CDMA Programming Manual
6
Programming Command Summary
Configuration Screen
The CONFigure subsystem commands are used to set the
controls and parameters associated with the basic system
requirement, file management, test condition, and test sequence
screens.
System Configuration Screen
The following commands are used to set the reference signal
oscillator source, date and time, beeper, RF attenuation,
firmware update, and so forth, which are fundamentally
required to operate the Tester.
File Management
DISP:CONF:FILE
Table 6-3 DISPlay Subsystem Command Summary
Item Command
Table 6-4 CONFigure Subsystem Command Summary
Item Command
Attenuation Control
CONF:LOSS ON|OFF|1|0
CONF:LOSS?
CONF:LOSS:RFIN <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>,<real 6>
CONF:LOSS:RFIN?
CONF:LOSS:RFOU <<
<real 1>,<real 2>,<real 3>,<real 4>,<real 5>,<real 6>
CONF:LOSS:RFOU?
Beeper Control
CONF:BEEP ON|OFF|1|0
CONF:BEEP?
10 MHz Reference Oscillator
CONF:ROSC?
Date
CONF:DATE <int YYYY>,<int MM>,<int DD>
CONF:DATE?
Panel Key Control
CONF:PKEY UNLOCK|LOCK
CONF:PKEY?
Printer Control
CONF:PRIN PMG800|USBM
CONF:PRIN?