Agilent Technologies N5340A, Installation Manual

Page: 30 / 34

30 Installation Guide
4
Getting Started
Starting an OBSAI Session
After installing OBSAI Protocol Tester, find out if it is starting fine.
The following procedure tells you about how to power up the system and
start a new session.
In this section, you will learn:
• To power up the system
• To start a new session
To power up the system
1 Power up the Controller PC.
Powering up the Controller PC starts the AgtResourceManager service.
This service keeps track of the chassis connected to the Controller PC.
2 Power up the Ethernet switch or hub if you have connected the chassis
through an Ethernet switch or hub.
3
Power up the chassis connected to the Controller PC.
You can power up the chassis using the power switch, which is at the
front of each chassis.
Powering up the chassis also boots the I/O modules installed in it.
4 View the matrix display of the I/O module.
After booting, the I/O module displays its number along with a trail of
pixel snake around the border of the display area.
To start a new session
1
Invoke the Tcl command prompt.
2
Load the
AgtClient
package into the Tcl interpreter.
To do this, use the following Tcl command:
package require AgtClient
3
Press the
ENTER
key on the keyboard to load the
AgtClient
package,
which has the entire OBSAI api.
The following output is displayed:
0.2
This connects the Tcl shell to the OBSAI system. The
0.2
value is the
version of the
AgtClient
package.
4 Specify the following command to start a new OBSAI exerciser session: