Agilent Technologies N5230AU-974, Installation Note

Page: 6 / 30

6 Installation Note N5230-90022
Tools Required for the Installation
ESD Equipment and Supplies Required for the Installation
Equipment Required for Post-Upgrade Adjustments
Overview of the Installation Procedure
Step 1. Remove the Outer and Inner Covers.
Step 2. Remove the Front Panel Assembly.
Step 3. Remove the 20 GHz Bottom Cables.
Step 4. Remove the Test Set Deck Front Panel.
Step 5. Remove the 20 GHz Top to Bottom Cables.
Step 6. Remove the 20 GHz Components.
Step 7. Install the 50 GHz Components.
Step 8. Install the 50 GHz Top to Bottom Cables.
Step 9. Assemble and Install the New Test Set Deck Front Panel.
Step 10. Install the 50 GHz Bottom Cables.
Step 11. Replace the Nameplate.
Step 12. Reinstall the Front Panel Assembly.
Step 13. Reinstall the Inner and Outer Covers.
Step 14. Enable Option F40.
Step 15. Perform Post-Upgrade Adjustments.
Description Agilent Part Number
T-10 TORX driver (set to 9 in-lbs) N/A
T-20 TORX driver (set to 21 in-lbs) N/A
5/16-inch torque wrench (set to 10 in-lbs) N/A
1-inch torque wrench (set to 72 in-lbs) N/A
Description Agilent Part Number
ESD grounding wrist strap 9300-1367
5-ft grounding cord for wrist strap 9300-0980
2 x 4 ft conductive table mat and 15-ft grounding wire 9300-0797
ESD heel strap (for use with conductive floors) 9300-1308
Equipment Type
Model or
Part Number Alternate Model or
Part Number
Power meter E4418B/E4419B E4418A/E4419A
Power sensor, 2.4 mm 8487A None
Adapter, 2.4 mm (f) to 2.4 mm (f) 11900B 85056-60007
RF cable, 2.4 mm (f) to 2.4 mm (f) 85133C 85133E