1-12
Installing the Test Set
Step 4. Install the System on a Bench Top or in an Equipment Rack
To Install on a Bench Top
1.
Place the test set and PNA on a bench top. In the example illustration shown below,
the system is placed on a riser as an alternative to the bench top. Make sure that
there is at least four inches of clearance on the sides and back of the system for
adequate ventilation.
The front panel test cables are shown only as a reminder to make sure they can easily
reach the test surface of the bench.
CAUTION
Consider the ventilation requirement described on page 11 when selecting
the location of your system.
2.
Continue with
“Step 5. Make the Interconnections between the Test Set and the PNA”
.