
8
Installation
90
User Guide
4
Loosely install the 4 or 5 T-10 Torx screws that came with the fan assembly into the LTM
oven door. See
Figure 45.
Fan bracket mounting screw locations
5
Place the fan assembly bracket over the mounting screws, then tighten the screws until
snug.
6
Route the fan cable through the slot and gap in the lower left of this bracket where it
attaches to the door.
7
Connect the fan cable to the electronics board at P6 (or P9 for module 2). See
.
Used for 5-in.
module
Slot
Slot