G4208A User’s Guide
129
4
Running Multiple-Vial Analyses
Synchronizing Analyses with External Devices
Synchronizing Analyses with External Devices
With an APG remote connector the system can be connected to external devices
in order to synchronize the analyses. This is necessary when an external device
needs some time in order to get ready for a new analysis and when transmission
of a start request is required (see
on page 101 for
further information on interfaces).
The synchronization mode can be chosen in the
Configure - System
screen.
Figure 86
Choosing the Synchronization mode
In any case, do all the analysis preparation using the Instant Pilot.
NOTE
A “Start” command is used to start the analytical run from the point of injection
and is usually issued by the autosampler.
A “Start Request” command causes the autosampler to take the next vial and
place it under the injection needle (see
“APG Remote / Enhanced Remote (Infinity
The Start button on the Instant Pilot is used to start sequence analysis.
