Agilent Technologies InfiniiVision 3000 X-Series, Programmer'S Manual

Page: 567 / 1232

:RECall Commands
24
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide 567
:RECall:ARBitrary[:STARt]
(see page 1088 )
Command Syntax
:RECall:ARBitrary:[STARt] [<file_spec>][, <column>]
<file_spec> ::= {<internal_loc> | <file_name>}
<column> ::= Column in CSV file to load. Column number starts from 1.
<internal_loc> ::= 0-3; an integer in NR1 format
<file_name> ::= quoted ASCII string
The :RECall:ARBitrary:[STARt] command recalls an arbitrary waveform.
For internal locations, the <column> parameter is ignored.
For external (USB storage device) files, the column parameter is optional.
If no <column> parameter is entered, and it is a 2- column file, the 2nd
column (assumed to be voltage) is automatically be selected. If the
<column> parameter is entered, and that column does not exist in the file,
the operation fails.
When recalling arbitrary waveforms (from an external USB storage device)
that were not saved from the oscilloscope, be aware that the oscilloscope
uses a maximum of 8192 points for an arbitrary waveform. For more
efficient recalls, make sure your arbitrary waveforms are 8192 points or
less.
See Also
• "Introduction to :RECall Commands" on page 566
• ":RECall:FILename" on page 568
• ":SAVE:ARBitrary[:STARt]" on page 576
N O T E
If a file extension is provided as part of a specified <file_name>, it must be ".csv".