Agilent G3485A Third Detector Box
Installation Instructions
3
3
Attach the side bracket of the flow module back-up plate to the stand-off
using an M4 x 25 mm screw.
4
Attach the previously removed gray label plate to the front bezel.
Attach the third detector flow frame
1
Orient the third detector box with the GC by positioning the circular
cutouts at the bottom edge of the frame with the four screw holes at bottom
edge of the GC.
2
Using a Torx driver, attach the frame first with two M4 × 0.7 × 25mm long
screws at the top edge of the frame and then with four M4 × 0.7 × 12mm
long screws through the circular cut outs at the bottom edge of the frame.
Figure 1
Third detector flow frame mounted to GC
Restore the GC to operating condition
1
Install the third detector side cover using two M4 × 10mm long Torx
flathead screws.
2
Replace the top panel.
3
Plug in the GC and turn on the power.
M4 x 25 mm top
screw locations
M4 x 12 mm bottom
screw locations
