Getting Started
Agilent Electrothermal Temperature Controller ETC 60 User’s Guide
24
To install the workhead:
1.
Connect the temperature sensor cable to the workhead.
Figure 24.
Temperature cable connected to the workhead. An older style cell heater cable is shown.
NOTE
The pins on the connector are sized differently and will only fit one way.
2.
Fit the ETC 60 workhead into the hole in the bracket and push down firmly to
seat it in the bracket. See Figure 20 on Page 21.
Figure 25.
ETC 60 workhead installed (Flame instruments left and Zeeman instruments right)
