Installation Note E8364-90019
11
Step 3. Raise the Receiver Deck
Refer to
for this procedure.
1. Place the analyzer bottom-side up on a flat surface.
2. With a T-10 TORX driver, remove the four screws, (item
{
), that secure the receiver deck.
3. Pull the latch pin (item
|
) towards the opposite side of the analyzer to release the receiver
deck. Be sure to pull only item
|
. The other two latch pins are the pivot pins for the
receiver deck. Pulling them will result in complete removal of the deck from the analyzer.
4. Lift the receiver deck to partially raise it, then release the latch pin (item
|
). Lift the
receiver deck to its fully raised position and ensure that the latch pin latches in the raised
position.
Figure 4
Receiver Deck, Raising
