10
Installation Note E8364-90012
Step 3. Raise the Receiver Deck
Refer to
for this procedure.
1. Place the analyzer bottom-side up on a flat surface.
2. With a T-10 TORX driver, remove the four screws (item
①
), securing the receiver deck.
3. Pull the latch pin (item
②
) towards the center of the analyzer to release the receiver deck.
Be sure to pull only (item
②
). The other two latch pins are the pivot pins for the receiver
deck. Pulling them will result in complete removal of the deck from the analyzer.
4. Lift the receiver deck to partially raise it, then release the latch pin (item
②
). Lift the
receiver deck to its fully raised position and ensure that the latch pin latches in the raised
position.
Figure 4
Receiver Deck, Raising
