Agilent Technologies E5070B, User Manual

Page: 602 / 769

596 Appendix A
Manual Changes
Manual Changes
Note on use
When the fixture simulator is ON and the port impedance conversion is ON, Z0 of all ports
to be saved must be set to the same value.
Operating Procedure
1. Starting VBA macro
Step 1. Press
[Macro Setup]
.
Step 2. Press
Load Project
.
Step 3. The Open dialog box appears. Specify the file name “D:\Agilent\SaveToTouchstone.vba”
and press the
Open
button.
Step 4. Press
[Macro Run]
to start the macro. (Refer to Figure A-10.)
Figure A-10 SaveToTouchstone dialog box
2. Saving data
Step 1. Select the number of ports (1 in Figure A-10) and test ports (2 in Figure A-10).
NOTE
You can selects 1 port or 2 ports as the number of ports when the maximum number of
channels/traces is 16 channels/4 traces or 12 channels/6 traces.
Step 2. Select a channel (3 in Figure A-10).
NOTE
The channel selected in this step has no relation to the active channel.
Step 3. Select the data saving format (4 in Figure A-10).
real - imaginary (RI)
real and imaginary parts
magnitude - angle (MA)
linear magnitude and phase (degree)
dB - angle (DB)
logarithmic magnitude (dB) and phase (degree)
Step 4. Press the
Save
button (5 in Figure A-10). Measurement of necessary data for the selected
channel in Step 2 starts.
NOTE
Regardless of the state of the trigger system, measurement is automatically performed