C
501
Communication with External Instruments Using 24-bit I/O Port
Timing Chart and Pulse Width
C. Communic
ation
with
External
Inst
ruments
Using
24-bit I/O
Port
Timing Chart and Pulse Width
When the formatted data calculation is completed during the sweep, a negative pulse is
provided. The pulse width of the sweep completion signal is shown in Figure C-3.
Figure C-3
Pulse width of /SWEEP END
Figure C-4 shows the timing chart for data output and write strobe signal output to ports A
through F.
Figure C-4
Timing chart of data output and write strobe signal
Table C-3
Value of T1 in Figure C-3 (typical)
Typical Value
T1
Pulse width of /SWEEP END
12
μ
s
Table C-4
Values of T1 through T2 in Figure C-4 (typical)
T1
Response time of write strobe signal
1
μ
s
T2
Pulse width of write strobe signal
1
μ
s
Summary of Contents for E5052A
