2 Laboratory setup requirements
Robot mounting specifications
22
BenchBot Robot Safety and Installation Guide
Robot mounting specifications
Attachment surface
The BenchBot Robot must be mounted vertically on the integration plates or
attachment surface. Be sure to plan the layout of the robot and other devices
before installing them.
Layout considerations
When planning the layout of the robot and devices, be aware that the robot or
any device can straddle two or more plates.
Robot base dimensions
Figure
BenchBot Robot base top view (left) and side view (right)
Robot base mounting specifications
Four M6 screws (supplied) are required to secure the BenchBot Robot to the
integration plate. The following diagram shows the base of the robot and the
spacing of the holes for the screws.
Figure
BenchBot Robot base mounting holes
20.1 cm
23.5 cm
1.0 cm
Dimension
Value
Width
23.5 cm (9.3 in)
Depth
20.1 cm (7.9 in)
Height
1.0 cm (0.4 in)
15.24 cm
19.05 cm
Summary of Contents for BenchBot
