G1369B LAN Interface User Manual
19
Getting Started
2
Installing and Cabling the LAN Interface
6
Carefully slide the LAN Interface into the slot. Some pressure may be
necessary to properly seat the board. Tighten the screws.
7
Disconnect your PC from the network and connect the PC network card to
the instrument's LAN Interface using a Crossover Network cable
(point-to-point) or alternatives, see
page 11
and
page 12
.
Figure 9
Connect the LAN cable to the correct connector
N O T E
In 1100/1200/1260 systems, the LAN Interface should be installed in the detector (DAD,
MWD, FLD, VWD) due to its higher data handling rate. If no 1100/1200/1260 detector
available, use the pump or the autosampler (in this order).
N O T E
The LAN Interface is shipped with the Bootp initialization mode and will use the
parameters (IP, Subnet Mask and Default Gateway addresses) from a Bootp server. If you
need another initialization mode or other settings, refer to “Initialization Mode
Selection”
on page 22
for details before doing the next step.
C A U T I O N
Be careful that you connect the LAN cable to the LAN Interface and NOT one of the CAN
connections. The CAN bus uses 12-Volt signals, and a misconnection to the CAN bus may
destroy network equipment on the other end of the cable.
LAN
comunication only
CAN for
inter-module
communication
only
