Agilent Technologies 93000 SOC Series, Training Manual

Page: 288 / 640

Vector and Pattern Management 10-6 Sequencer Instructions
288
Agilent 93000 SOC Series User Training Part 1, October 2004
10-6 Sequencer Instructions
The sequencer has its own set of instructions which you can use to
control the execution of your test. You enter the instructions in the
Instr column of the Vector Setup window.
The default instruction is GENV (generate vectors) for every vector, but
the system does not display it and you do not have to enter it.
Sequencing Instructions If you hold the left mouse button down in the
Instr
column, a menu of
the different sequencing instructions becomes available (see Table 2 ).
You can include comments in the sequencer instruction column. To do
this, just enter a “#” in front of the comment text.
You can enter more than one instruction per line. To do this, separate
the instructions by “;”. For example,
MATCHEND; CTIM 4; CLEV 3
is a valid entry in the I
NSTR
column.
If there is not enough space in the sequencer instruction column to
display all instructions a “;” is shown instead of each instruction, which
is not displayed.
You can modify the width of the sequencer instruction column in the
Define Table Format dialog box (see page 261 ).
Table 2 Sequencing Instructions
CTIM change the Timing Set
CLEV change the Level Set
REPEAT repeat vectors
LOOP and LOOPEND endless loop
MATCH and MATCH-
END repeat until no errors
STOP stop the sequencer (for debugging purposes only)
# comment