Agilent Technologies 83236B, Operating Manual, Page: 50 / 164

50
Chapter 2, Installation
When Used with Agilent 8921A for CDMA Base Stations Tests
When Used with Agilent 8921A for CDMA Base Stations Tests
Unpack the PCS
Interface and
Accessories
Follow these steps to prepare the Test System for setup:
1 Unpack the test equipment and accessories.
NOTE: This product passed all applicable electrical and mechanical inspections before it was
shipped from the factory. As soon as you receive it, check that it is not damaged and that
all accessories are present (see table 2 on page 19). Should this product be damaged or any
accessories be missing, contact your local Agilent Technologies sales office or the
company from which you purchased it.
2 Placing the equipment:
a If you are placing the Test System horizontally (on a bench top, for example) place
the Test Set (together with the Cellular Adapter) on the top of the PCS Interface.
Position the bumpers (feet) of the Test Set so that they are stably seated between
the forward and rear bumpers of the PCS Interface. Refer to figure 10.
Figure 13 Horizontal stacking configuration (side view) for the Agilent 8921 Test Configuration
Test Set Cellular Adapter
PCS Interface