©
Agilent Technologies 1989–2002
Agilent 3070 / 79000 Site Preparation
11
:
Warnings
The following general safety precautions must be
observed during all phases of operation, service, and
repair of this product. Failure to comply with these
precautions or with specific warnings elsewhere in
this manual violates safety standards of design,
manufacture, and intended use of this product.
Agilent assumes no liability for the customer’s
failure to comply with these requirements.
Ground the Equipment:
For Safety Class I equipment
(equipment having a protective earth terminal), an
uninterruptable safety earth ground must be provided
from the main power source to the product input wiring
terminals or supplied power cable.
DO NOT
operate the product in an explosive
atmosphere or in the presence of flammable gases or
fumes. For continued protection against fire, replace the
line fuse(s) only with the fuse(s) of the same voltage and
current rating and type.
DO NOT
use repaired fuses or
short-circuited fuse holders.
Keep away from live circuits:
Operating personnel
must not remove equipment covers or shields.
Procedures involving the removal of covers or shields
are for use by service-trained personnel only. Under
certain conditions, dangerous voltages may exist even
with the equipment switched off. To avoid dangerous
electrical shock,
DO NOT
perform procedures
involving cover or shield removal unless you are
qualified to do so.
DO NOT operate damaged equipment:
Whenever it
is possible that the safety protection features built into
this product have been impaired, either through physical
damage, excessive moisture, or any other reason,
REMOVE POWER and do not use the product until
safe operation can be verified by service-trained
personnel. If necessary, return the product to an Agilent
Sales and Service Office for service and repair to ensure
that safety features are maintained.
Do not service or adjust alone:
Do not attempt internal
service or adjustment unless another person, capable of
rendering first aid and resuscitation, is present.
Do not substitute parts or modify equipment:
Because of the danger of introducing additional hazards,
do not install substitute parts or perform any
unauthorized modification to the product. Return the
product to an Agilent Sales and Service Office for
service and repair to ensure that safety features are
maintained.
Ensure Rack Stability:
To ensure stability of the test
bay, place heavier instruments near the bottom of the
rack.
