26
31025 R0
5
5.. O
Op
pe
erra
attiio
on
n
Before continuing, ensure you have completely read and understood this manual’s
Safety section, in addition to the safety information in the section(s) below.
This manual is a supplement to the X130 Series Operator Manual. Please ensure that
you have read and understood that manual.
5.1. Operation Safety
• Keep away from rotating and moving parts, including the auger flighting, drive components,
shafts, and bearings.
• Always operate with guards, covers, and shields in place.
• Have another trained person nearby who can shut down the equipment in case of accident.
• Keep the work area clear of bystanders.
• Keep the work area clean and free of debris.
• Ensure maintenance has been performed and is up to date.
5.2. Transport Preparation
Position the X-Tend hopper in the transport configuration following the X130 Operator Manual instructions and
the following:
1. Fully extend the X-Tend hopper to reach the lift arm on the main auger.
2. Make the hopper as flat as possible to avoid interference with the frame before lifting the swing into
transport, as shown in
3. Attach the winch cable to the hopper, lift into position, and secure the transport chain, as shown in
.
Note
The X130–74 connects to the hopper in a different position than the other models.
X-TEND HOPPER – X130
