AGI WHEATHEART X Series, Assembly And Operation Manual

Page: 70 / 126

3. A
SSEMBLY
W
HEATHEART
- X-S
ERIES
13" A
UGERS
3.17. I
NSTALLING THE
H
OPPER
L
IFT
A
RM AND
W
INCH
X130-74, X130-84, X130-94
70 30787 R2
3.17. INSTALLING THE HOPPER LIFT ARM AND WINCH
Table 3.15 provides a list of parts required to install the intake hopper lift arm and
winch.
1. Determine which side of the auger the hopper will be operating on.
Note: Feed side of hopper must face the main auger when in transport.
2. Position the hopper lift arm assembly on the mount bracket on top of the
lower auger tube with the arm overhanging the side of the auger that the
hopper will be operating on.
3. Fasten hopper lift arm assembly to the mount bracket with four 7/16” x 1-1/4”
bolts and 7/16” locknuts (Figure 3.37).
4. Install winch and winch bracket assembly to auger boot (opposite to side of
hopper operation) with one mount pin and a hairpin (Figure 3.38).
5. Thread the cable through the hopper lift arm and pull the cable to the winch.
6. Wrap the over and around the winch spool at least three times, then insert
the cable end through the hole provided in the side of the spool and secure
the end with the provided cable clamp (Figure 3.39).
7. To place hopper into transport position, attach cable hook to hook on the
hopper transition, then fully raise hopper with intake side facing main auger.
Secure hopper to lift arm by connecting the safety chain (Figure 3.40) to the
hopper cable attach bracket.
Table 3.15 Parts Required, Installing the Hopper Lift Arm and Winch
Part Number Description Amount
20030 Hopper lift arm assembly 1
19152 Manual winch assembly 1
18074 Mount pin 1
19463 Hairpin 1
18698 7/16” x 1-1/4” bolts 4
17593 7/16” locknuts 4