AGI WHEATHEART X Series, Assembly And Operation Manual

Page: 67 / 126

W
HEATHEART
- X-S
ERIES
13" A
UGERS
3. A
SSEMBLY
X130-74, X130-84, X130-94 3.16. I
NSTALL
L
OW
P
ROFILE
I
NTAKE
H
OPPER
30787 R2 67
1. Attach the transition to the intake hopper with two 5/8” x 1-1/2” bolts and 5/8”
locknuts (19600). DO NOT over-tighten; tighten to a slightly loose fit only as
these bolts act as pivot points (Figure 3.33).
Figure 3.33 Installing the Transition
2. Clean dirt and paint from inside the u-joint and flighting shaft end, grease the
shaft end, then insert a Woodruff key (Figure 3.34).
3. Raise and support the hopper tube spout head on a stand about 50” high.
4. Open the service door on the transition, then bring the tube and transition
together guiding the flight shaft into the u-joint (Figure 3.34).
5. Secure the tube to the pivot-connector on the hopper with twelve
7/16” x 1-1/4” bolts and 7/16” locknuts.
6. Tighten set screws on u-joints, then close and secure the service door.
Table 3.14. Parts Required, Install Low Profile Intake Hopper
Part Number Description Amount
29978 Low profile hopper 1
21299 Spout head and tube 1
29977 Transition 1
20051 Cable attach bracket 1
17522 Wheel 4
17394 Wheel pins 4
20461 Inspection hatch bar 1
19463 Hairclip connectors 1
19224 Woodruff key 1
29166 Spout head retainer 4
29152 Spout head spacer 4
19538 5/16” x 3/4” bolt 10
18698 7/16” x 1-1/4” bolt 15
17593 7/16” locknut 15
19590 5/8” x 1-1/2” bolts 2
19600 5/8” locknuts 2
5/8” X 1-1/2” BOLTS
5/8” LOCKNUT
5/8” LOCKNUT
TRANSITION