![AGI Westfield WCX1535FL Operator'S Manual Download Page 61](http://html1.mh-extra.com/html/agi/westfield-wcx1535fl/westfield-wcx1535fl_operators-manual_2867021061.webp)
P1512134 R2
61
2. Move the tension roller to its loosest position.
3. Pull all the slack to the lacing area.
4. Remove the lacing retainer clip and pin.
5. Attach one end of the replacement belt to the belt end being removed, closest to the hopper.
6. Pull the old belt out and the new belt will be threaded into place.
7. Disconnect the old belt.
8. Reattach conveyor belt ends together. If required, use a ratchet strap clamped to both ends of belt to cinch
belting ends together.
Figure 28.
Using the Ratchet Strap
1
3
4
2
9. Install the lacing pin and crimp the retainer clips onto each end of the lacing pin, see
.
10. Remove the ratchet strap and tighten the conveyor belt (see “Tension the Conveyor Belt”).
11. Check and set the belt alignment (see “Align the Conveyor Belt”).
12. Engage the conveyor drive. Allow it to run for 30 seconds, then shut down the conveyor and inspect the
lacing.
S-DRIVE FIELD LOADER – PORTABLE GRAIN BELT CONVEYOR