3. C
ONVEYOR
C
OMPONENTS
H
I
R
OLLER
- B
ELT
C
ONVEYORS
3.2. C
OMPONENT
L
IST
H
I
R
OLLER
, M
INI
R
OLLER
, L
O
R
OLLER
& H
I
L
IFE
24
P115506 R3
3.2.7. T
AIL
S
ECTIONS
Figure 3.13 Standard Tail Section w/ Inner & Outer Box Take-Up
3.2.8. T
AKE
-U
P
S
ECTIONS
There is one take-up rod on each side of the take-up section on the centerline of
the tail shaft bearings and they are used to tighten the belt (Figure 3.14).
Figure 3.14 Tail Take-Up Section w/ Rods and Leveling Rods
S
PECIAL
T
AKE
-U
P
S
ECTIONS
The take-up head section works in the same manner as a sliding box tail. The
take-up rods located on the sides tighten the belt (Figure 3.15).
Figure 3.15 Head Take-Up Sections w/ Rods and Leveling Rods
The sliding plate take-up head section uses a sliding plate to mount the head
pulley bearings. The conveyor belt is tightened with the take-up rods mounted
directly behind the bearing mounting (Figure 3.16).
