H
I
R
OLLER
- B
ELT
C
ONVEYORS
3. C
ONVEYOR
C
OMPONENTS
H
I
R
OLLER
, M
INI
R
OLLER
, L
O
R
OLLER
& H
I
L
IFE
3.2. C
OMPONENT
L
IST
P115506 R3
19
Figure 3.3
Note:
The shaft mount drive with synchronous cog-belt (Figure 3.3) is the most
common type of drive. The in-line drive with synchronous cog-belt final drive belt
and in-line drive with direct coupled drive (not shown) are not as common.
3.2.3. T
RUNKING
S
ECTIONS
H
EAD
/ D
RIVE
E
ND
T
RUNKING
S
ECTIONS
• High leg end channel, inspection door location, and special flanges (Fig-
Figure 3.4
T
AIL
/ N
ON
-D
RIVE
E
ND
T
RUNKING
S
ECTIONS
• High leg end channel, inspection door, and two equal middle flange chan-
nels and opposite end of the high leg end channel.
I
NTERMEDIATE
T
RUNKING
S
ECTIONS
• Each intermediate section has two equal flange channels, an equal flange
channel on the end, and another in the middle of each section (Figure
3.5).
