AGI 1535, Operator'S Manual, Page: 36 / 68

36 8210–00009 R1
Figure 10. Typical Grain Conveyor Placement for Filling Bins
KEEP AWAY!
OVERHEAD WIRES
wheel chocks
Under Hopper Bottom Bins
1. Center the conveyor between the hopper bin’s vertical legs.
2. Collapse the cloth hopper until the conveyor is fully positioned under the bin.
3. Move the conveyor into place. Do not allow the conveyor tube or components to contact the bin.
4. Raise the conveyor to the desired height.
5. Make sure that gravel is not jammed against the belt under the hopper.
6. Place chocks in the front and back of each wheel and anchor the intake end.
5.3. Positioning the Conveyor with a Mover Kit
Æ
When equipped with a self-propelled Mover Kit:
Before Operating the Mover Kit:
• Ensure the area around the conveyor is reasonably level and there is adequate clearance for making wide
turns.
• Check the hydraulic oil level.
Running the machine on low oil will overheat the system and can damage components.
To Operate the Mover Kit:
1. Engage the over-center handle at each wheel ( Figure 11 on page 37 ) and check that the gears are fully
meshed. If necessary, refer to Pinion Gear Adjustment section.
5. PLACEMENT S-DRIVE FIELD LOADER – PORTABLE GRAIN BELT CONVEYOR