AGI 15100SA, Assembly Manual

Page: 50 / 82

50 P1512161 R0
Table 19. Transport Adjustment Arm Components
Item
Description Quantity
5
Transport Adjustment Arm
1
6
1/2" x 5" Pin Hitch
1
7
3/16" x 3-1/4" Hair Pin
1
Figure 42. Attaching Transport Adjustment Arm
Attach the Hydraulic Winch and Lift Cable
1. Attach the hydraulic winch (1) to the winch plate using 3/8" x 1-1/4" bolts (2), 3/8" flat washers (3), and
3/8" locknuts (4). See Figure 43 .
2. Install the cable sheave (5) to the transport adjustment arm using 1/2" x 3" bolts (6) and 1/2" locknuts (7).
3. Feed the winch cable (8) over the cable sheave and attach it to the spool (minimum 3 wraps around the
spool, feed the cable through hole in side of spool, and secure with clamp and clamp hardware). See Figure
44 .
4. Attach the grab hook (9) to the end of the cable using two 5/16" cable clamps (10).
Table 20. Hydraulic Winch and Lift Cable Components
Item
Description Quantity
1 Hydraulic Winch 1
2
3/8" x 1-1/4" Hex Bolt
4
3
3/8" Flat Washer USS Plated
4
4
3/8" Nylock Nut
4
5
2-3/4" OD Cable Sheave
1
6
1/2" x 3" Hex Bolt
1
7
1/2" Nylock Nut
1
3. ASSEMBLY SWING AWAY CONVEYOR – PORTABLE GRAIN BELT CONVEYOR