Chapter 1 — Preparing the scanner
7
Unlocking the scanner
The scanner’s optical box contains all optical components and rides back and forth during the scan.
A carriage lock holds it in place during shipment. You have to push up this carriage lock before
powering up the scanner.
1.
Place the scanner on a horizontal, flat surface and pull it forwards until you can see the carriage
lock on the underside.
2.
Remove the piece of Styrofoam.
3.
Press in the detent on the side of the carriage lock.
4.
Push the carriage lock up.
The carriage lock comes loose. Your scanner is unlocked.
5.
Move the scanner back on your desktop. Allow a minimum of 10 cm (4") free space around
each side of the scanner and a minimum of 15 cm (6") at the rear side of the scanner.
Summary of Contents for StudioStar
Page 27: ...Chapter 2 Installing the scanner 27 ...
Page 35: ...Appendix A Using the transparency option 35 6 Lower the transparency option ...
Page 40: ...Appendix B Using the document feeder option 40 ...
Page 42: ...Appendix B Using the document feeder option 42 10 Raise the transportation module ...