No identification code detected
This error message appears when the Film Identification tag is not readable.
There are two possible solutions for this problem:
Topics:
•
Reload the current film pack or load another film pack
•
Overrule the Film Identification tag of the film pack
Reload the current film pack or load another film pack
To reload the current or another film pack
1.
In case the printer does not start printing after re-inserting a film pack,
first check if this film pack is inserted correctly.
If the printer still does not resume printing, the following message will
appear:
Remove and re-insert
film pack -including
protective sheet-
properly. follow
loading instructions
正确移除和重新
插入胶片包
-
包括
保护片。
护遵循
装入护明
2.
Open the input tray and check again if the film pack is inserted correctly. If
you re-insert the film pack, the printer will perform the same check
sequence until printing is resumed.
Overrule the Film Identification tag of the film pack
If the “Overrule RF-tag Reading” setting is active, you can overrule the Film
Identification tag setting of the current film pack. In this case you can
continue printing using a limited Maximum Density.
Note
:
Only your local service organization has the possibility to
enable the “Overrule RFtag Reading” setting!
To overrrule the Film Identification tag of the film pack
1.
In case the printer does not start printing after inserting a new film pack,
check if this film pack is inserted correctly.
If the film pack is inserted correctly and the printer does not resume
printing, the following message will appear:
Drystar Kiosk Operator Manual | Problem solving |
95
0401B EN 20211008 1002