AGFA DRYSTAR AXYS, Service Manual

Page: 60 / 461

DD+DIS033.07E
Controls, Connections and Setup Procedure
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 1 DRYSTAR AXYS Chapter 1 / 24
06-2008 Type 5367/100 Agfa Company Confidential
5.4.1 Mammography specific Image Adjustments
NOTE:
By default the Mammography printing functionality of the printer is switched off.
Two conditions have to be fulfilled to allow printing of Mammography images:
•
Mammo license is activated. See section 3.6.
•
A DICOM host profile for the Mammo modality with setting "Mammo modality
= yes" has to be created. This 2nd step is described here.
In case the printer has no Mammo modality as input, skip this step.
(1) In the browser pages select "Service Engineer Tools - DICOM profile editor -
New".
(2) Enter Nickname (A).
(3) Enter modality AE title (B).
(4) Select "Mammo Modality = yes" (D).
(5) If a small clear border is required (See Figure 17 next page)
- adjust “image orientation” to “r 180” (C)
- switch on Mammo CWR Rotation* (E).
(6) In case the modality and printer is part of an Agfa Solution, make adjustments as
defined in the solution requirements.
Yes
r180
Nick Name:
Use this profile only for incoming 'Calling AE title':
Mammo modality:
Image orientation:
CR QS Mammo
A
B
D
C
E
QS
OK Cancel Show Defaults Show last Input
HELP Host Profile: CR QS Mammo
...........................................................
...........................................................
...........................................................
...........................................................
No
Mammo CWR Rotation:
536701gk.cdr
Figure 16
*
CWR = C hest W all R otation