AGFA DRYSTAR AXYS, Service Manual

Page: 165 / 461

DD+DIS033.07E
Repair and Service
Tools and Auxiliary Means
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
4.3 Emergency SW Installation on a printer in "Error - System Failure" state
Purpose
This chapter describes the SW Installation on a printer in ERROR - SYSTEM
FAILURE state.
IMPORTANT:
The software installation procedure
described here formats the hard disk.
In case you select "NO" at question
"Do you want to preserve config" the
configuration data are erased.
In this case the printer is only in the
same state than before, if an up-to-
date backup is available.
In case the CF card is lost or not
readable the complete printer setup
has to be redone.
Emergency SW FOUND
ON EXTERNAL CF-card
Install emergency
SW? YES (V) NO (X)
Emergency SW Install
Do you want
to preserve config?
YES (V) NO (X)
536632gc.cdr
Figure 59
SW
Installation
on empty HD
Edition 1, Revision 0 DRYSTAR AXYS Chapter 3.2 / 59
10-2007 Type 5367/100
Agfa Company Confidential
5366_Reg01_017_e.cdr
초
2
(1) Insert the CF card with the printer
"Emergency_Install" software in
the CF card reader
(2) Reboot the printer
(3) At question "Do you want to
preserve config?" select
"NO" in case you want to erase
the complete configuration
"YES" in case want to keep the
current configuration. Refer to
Figure 59 and to info below.
(4) Follow the further instructions on
the local keypad.
(5) Select menu "5 Restore
Configuration" to reload the
previous configuration when
finished.
Figure 60