AGFA Avantra 36/44, Service Manual, Page: 33 / 521

Section I: Imagesetter
Installation 1-9
Figure 1-5 Removing the channel bolts.
➀
–Outer channel bolts (3 per skid). Loosen the two bolts at each end first, leaving
the center bolt in place.
➁
–Inner channel bolts (4 per end channel) connecting the
end channels to the imagesetter frame.
➂
–Imagesetter frame.
➃
–End channel (1 of 2).
➄
–Outer channel bolt.
➅
–End channel.
12. Loosen the four (4) inner channel bolts, left and right, on the bottom of the
end channels. Refer to Figure 1-5.
WARNING:
Do not remove the bolts.
13. Remove the two (2) center channel bolts, one on each side of the center
channel. Refer to Figure 1-5. The bolts hold the center channel to the pallet
beam. There are no bolts holding the center channel to the imagesetter
frame. Once the center channel bolts are removed, the channel should
fall.
14. Slide the center channel toward the rear and remove.
2
4
6
5
3
1
6