AGCO Massey Ferguson 1547, Service Manual

Page: 44 / 51

4283094M2 02-13
General Information and Specifications
GENERAL INFORMATION AND SPECIFICATIONS
GENERAL INFORMATION
Introduction
This manual has been prepared to provide information
concerning the servicing and overhaul of the following
ISEKI engines, assuming that trained mechanics perform
this work at workshops outfitted with the required
equipment.
This manual does not apply to field work where adequate
service tools and equipment are not available. The
contents of this manual cover all of the necessary
information which would be required for operations in a
workshop. These include construction, the functions of
major components, specifications, disassembly and
reassemble instructions, inspection and adjustment
instructions, troubleshooting, etc. Figures mentioned in
this manual are standard values established by ISEKI for
the E4D series engines. Consequently, when a
non-ISEKI part has been installed on the engine or
adjustments and repairs have been made in a manner
other than as specified in this manual, the values
mentioned herein are inapplicable and useless.
Consequently, ISEKI does not assume responsibility for
any problems or damage caused by a value deviation due
to maladjustment or by the use of unauthorized parts.
Be sure to follow the instructions mentioned in this
manual when servicing the engines in a workshop.
Values necessary for servicing the engines are
mentioned in each instruction section, besides which all
of the service reference values are summarized in the
SERVICE STANDARDS TABLE. Please refer to this table
before commencing service work to assure efficient
maintenance and operation. Prompt and reliable
servicing is a critical factor in following the operating
Procedures and precautions included in this manual,
while keeping safety in mind at all times. The ultimate
objective of this manual is to provide you with adequate
information to service the engines most effectively and
economically, and in the end to gain a favorable
reputation for ISEKI products among its users.
NOTE: All information, illustrations, and specifications
contained in this technical manual are based on
the latest information available at the time of
publication. The right is reserved to make
changes at any time without notice.
Engine / Tractor Cross Reference
1547 / ST47A / MT285B E4CG
1552 / ST52A / MT295B E4DE