T951
T528
T952
T529
T953
T530
T954
1.1.6 Change wheels
DANGER:
Secure the tractor to prevent it rolling.
DANGER:
Always use support stands when working on the vehicle
WARNING:
Make sure that the surface on which jack is placed is flat, solid and non-slip. Do not place
wooden blocks or similar supports under the jack. Otherwise, the vehicle may fall off the
jack and seriously injure you.
WARNING:
Do not start the engine at any time while changing wheels.
WARNING:
The jack is only intended to lift the vehicle for a short period of time while wheels are
being changed.
WARNING:
Make sure that the permissible vertical load capacity and lifting height of the jack are not
exceeded.
WARNING:
Extra equipment such as wheel weights, twin tires etc. must be removed before changing
a wheel.
If you do not position the jack under the jacking point correctly, the vehicle
• may fall off the jack
• and you or other individuals
• may be injured.
Instructions for using wheel nuts
• Replace any wheel nuts that are damaged or showing signs of rust.
• Never oil or grease wheel nuts. Lubricated wheel nuts can come loose from the wheel hub.
• Only use wheel nuts that are intended for use with the wheel and vehicle concerned.
• Do not tighten wheel nuts with the vehicle raised. The vehicle may tip over
• After changing the wheels, retighten wheel nuts after 10 running hours and check that tightening
torque is as specified (see technical data).
GUID-D1AD9F04-304D-4255-AC80-90D73D619A18 [V2]
1. Tractor
1-20
FENDT 700 Vario S4
X990.005.538.013
