1.4 Lubrication and maintenance chassis
1.4.1 Maintenance introduction
IMPORTANT:
Perform Maintenance procedures at regularly scheduled intervals. Failure to perform regularly scheduled
maintenance will result in damage to the machine's components or engine. The maintenance schedule is a
recommended guide for correct maintenance of the machine.
DO NOT change the schedule unless you increase the frequency of service when operating the machine in
very hot, cold, dusty or corrosive conditions.
Decals are located near the eductor and operator control station.
NOTE:
All service items shown in the table below can be done by the operator of the machine. All other
service and maintenance should be done by a dealer and/or an AGCO educated mechanic.
Use the hourmeter as a guide for maintenance intervals.
The maintenance intervals can be shown in both operating hours and time.
Example: 10 Hours or Every Day. Use the interval (operating hours or time) that comes first.
1.4.2 Maintenance schedule
Service Item
Hours
Initial
100
Daily
100
250
500
1000/
annual
Daily
[1]
1. Check air pressure-tires
X
2. Check all decals
X
3. Remove water from air-reservoirs
X
4. Check coolant level
X
5. Check fuel water separator
X
6. Check engine oil level
X
7. Check for leakages
X
8. Clean air filter valve vacuator
X
9. Check hydraulic oil level
X
10. Check hand rinse tank
X
11. Check wheel nuts
X
12. Clean heat exchanger
X
13. Check cab pressure indicator
X
100 Hours
[1]
14. Check cab mounts
X
15. Check hydraulic hoses and lines
X
16. Check engine belts and tensioner
X
17. Check battery fluid and battery cables
X
18. Clean or replace air cleaner elements
X
250 Hours
[1]
19. Check oil level gearbox wheel motors
X
1. General
RoGator 600C
1-21
644410-1
