AGC Pro31-M, Operation And Maintenance Manual

Page: 8 / 19

4
Opening the Frame:
To open the frame, rotate the spindle screws counter-clockwise. As with closing, alternate between
each spindle to ensure even opening. The follower will move back as the plate pack expands to its
uncompressed state. As the spindles retract the pushtubes may disengage from the spindles. This could
allow the pushtube to rotate about the supporting pin causing the push-tube to swing down (see figure 5).
Caution should be exercised when opening the frame to prevent injury by the pushtube.
Figure 5
Pushtube Swing
When retracting the spindles, it is recommended to back the spindles out only to the point that the
plates can be removed. Once the spindles have been adequately retracted the handle should be moved to
the center (neutral) position.
Frame Assembly Instructions:
Assembling a Pro31 frame requires careful attention to detail and should only be attempted by
qualified equipment installers or maintenance technicians. The components are large and could cause
serious injury or death if mishandled. The procedure described here is the method used at the factory to
assemble the press. Your particular site requirements and limitations may require deviation from this
description. It is assumed that the persons installing this heat exchanger are familiar with processing
equipment and sanitary installation methods. If you have questions about erecting a Pro31 frame or any
procedure described in this section, please contact AGC or your local AGC distributor.
Upon delivery, uncrate all components and inspect for damage. Check the drawing package and
packing slip to ensure all components are present. To complete this assembly you will need two sets of
jack stands (2 stands 19” tall and 2 stands 25¾” tall), a forklift truck, a socket wrench with an 8 (eight)
inch extension, a 1⅞” socket, a lifting sling rated for 4000 lbs cinch, and a spirit level (or other level
measuring device).