AGA PRO+ APRO36DF, User Manual & Installation & Service Instructions

Page: 37 / 48

INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
35
ArtNo.000-0012 - Securing the plinth
ArtNo.272-0009 - Prof+ pyro - Grate layout
Seal the Openings
Seal any openings in the wall behind the range and in the
floor under the range when hookups are completed.
IMPORTANT:
When all connections are completed make
sure the flow of combustion and ventilation air to the range
is unobstructed.
Leveling
Place the range in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the range or the units. Install the oven racks
in the oven. Check for levelness by placing a level or a cup,
partially filled with water, on one of the oven grids. If using a
spirit level, take two readings with the level placed diagonally
first in one direction and then the other.
The rollers can be adjusted to level the range. To adjust the
height of the rear of the range use the leveling tool supplied
to turn the adjusting nuts at the front bottom corners of the
range.
Final Fitting
Installing the Toe Kick
Remove the 3 screws for the toe kick mounts along the front
bottom edge of the range (Fig.7-31). Fasten the toe kick
using these screws (alternative color screws can be found in
the loose parts pack).
Fitting the Grates
Make sure that the grates are in the correct position and
seated properly (Fig.7-32).
Refitting the Storage Drawer
To replace the drawer in the range, pull the side rails fully out
(Fig.7-33).
Carefully move the drawer back between the rails and rest it
on the side rails (Fig.3-34).
Slide the drawer back onto the side rails so that the clips click
into position.
Refitting the Oven Door
To refit the door, slide the hinges back into their slots. Rotate
the locking ‘U’ clips back to fit onto the hinges.
Fig.7-32
Fig.7-31
Drawer
Rail
Make sure the inner
rail is forwards
Fig.7-34
Fig.7-33