5. Fit the pan supports in the following order The pan supports are marked on the underside to
correspond to the markings below. The pan supports must locate in the recesses in the
hotplate casting. (See Fig. 8A & 8B)
16
Fig. 8A
DESN 513515
DESN 513514
Fig. 8B
TO ADJUST PAN SUPPORT LEVEL
1.
Loosen retaining nut using 8mm spanner (See Fig. 8B).
2.
To prevent rocking adjust the pan support foot using 2.5mm allen key.
3.
Check pan support is level with opposing pan supports.
4.
Retighten retaining nut.
HANDRAIL FITTING
1.
Position handrail assembly onto locating studs at each end of facia. Ensure the grub screw
at each end of the hand rail is facing downwards.
2.
Push handrail assembly fully against facia and lock in place by tightening 2 grub screws
(2
1
/
2
mm). (See Fig. 6A).
Summary of Contents for Four-Two Series
