AGA 115V Installation, Operation & Maintenance Instructions Manual Download Page 3

Select Location

The proper location will ensure peak performance of your
appliance. Choose a location where the unit will be out of
direct sunlight and away from heat sources. Best
performance will be maintained when installed within the
following parameters: 

A gap of 24in (606mm) is recommended between units
for moving the wine chiller. A clearance of 3in (76mm) is
required to the side of the unit that the hinges are located
on to allow for the door to open 90° degrees. Please see
diagram for recommendations for built in applications. 

Cabinet Clearance

Adjacent cabinets and countertop can be installed on top,
back and sides of the unit as long as the grille and door
access remain unobstructed. Ventilation is required for the
bottom front section of the unit where the grille is located.
Keep this area open and clear of any obstructions.

Make certain that the leveling legs supplied with the wine
cooler are installed according to the instructions. Leveling
adjustments can be made by raising or lowering the glides
on the bottom of the unit.

Electrical Connection

Use nominal 115 volt, 60 cycle AC only. DO NOT USE AN
EXTENSION CORD

Grounding Method

This product is factory equipped with a power supply cord
that has a three-pronged grounded plug. It must be
plugged into a mating grounding type receptacle in
accordance with the National Electrical Code and
applicable local codes and ordinances. If the circuit does
not have a grounding type receptacle, it is the
responsibility and obligation of the customer to exchange
the existing receptacle in accordance with the National
Electrical Code and applicable local codes and ordinances.
The third ground prong should not, under any
circumstances, be cut or removed. All U.L. listed
refrigerated products are equipped with this type of plug.

Installing Your Refrigerated Wine Cooler

All specifications and product design subject to change without notice. 

Such revisions do not entitle the buyer to corresponding changes, improvements, 

additions, replacements or compensation for previously purchased products.

3

Ideal Ambient Temperature Range

Built-in

65° – 80°F

Free-Standing

65° – 90°F.

wall structure

adjacent cabinet

left hand swing

right hand swing

3“/76mm

24”

24”

DISCONNECT POWER SOURCE BEFORE ADJUSTING

LEVELING LEGS 

THIS UNIT SHOULD NOT, UNDER ANY

CIRCUMSTANCES, BE UNGROUNDED. 

Summary of Contents for 115V













Reviews: