3
METER FUNCTIONS
The “Meter Function” switch selects the type of
measurement being made. Select from the following:
VOLTS 0 to 50 Volts DC with automatic polarity sensing
FREQ Frequency 0 to 1000 HZ
CONT “Continuity” or “Ohms” 0 to 2000
The “Connected Point” switch selects the testing method.
There are 4 options. TEST, PATCH, COAX, or BATT CHECK
When dialed to TEST the
standard meter test leads are installed in
the RED outlined lead jacks. The meter can
then be used as you would a standard test
meter.
Dial to PATCH to use the Patch Cables
connecting at the Green outlined lead
jacks. This allows an easy connection to
the wires connecting the Display console
to the sensors.
Setting the CONNECTED POINT to COAX allows for an
easy connection to a TNC type coax connector. Most GPS
receivers send 5 volts to the antenna to operate an
internal amplifier. Disconnect the cable from the gps
antenna and re-install at COAX on the HT101S. When
VOLTS is selected you should see 5 to 12 volts on the
meter indicating a good connection from the antenna
connection to the gps receiver.
When dialed to BATT CHECK and VOLTS the meter indicates the
current internal battery voltage. Fully charged it may read as high as
13.5 VDC. The tester will function properly until below 12 volts. No
wire connection is required. Battery can be checked while
performing other tests.
The “Pulse Catcher” LEDs blink when pulses are present on the wire
being tested. This function is active when “Frequency” is selected.
Summary of Contents for HT101S
Page 1: ...1 HT101S Reference Manual...
