Page 3
Assembly Procedure (FS-ATV-15)
Step 1
Step 2
Normally, the sprayer will be mounted on an ATV with the pump as-
sembly at the operator’s back and the spray wand will be at the rear of
the unit. Right Hand (RH) and Left Hand (LH) sides of the sprayer are
determined as if you are standing behind the sprayer,
looking at it (facing forward)
After removing the tank from the box, start the assembly procedure by
turning the tank upside down on a stable, flat surface.
A phillips head screwdriver is required for this step.
(**) Mount tank brackets to the underside of the tank as shown in Step
1. Use (4) flat head screws to secure it to the tank. The tank will rest
on the surface of the brackets. Make sure the brackets are parallel
with each other before tightening down the bolts. Do not over-tighten.
Detail A
After your tank brackets are securely attached, turn the tank as-
sembly over and position it so that the cam handles which extend
beyond the back of the tank are facing you and just hanging over
the edge of the table or flat surface you are assembling this on.
Secure the boom mounting brackets to the tank mounting brack-
ets with Cam handles as shown in Detail A. You can position
them as needed within the slot on the bracket. Just be sure that
the surfaces of both brackets are even with each other.
You are now ready to mount this unit to an ATV, using ratchet
straps (NOT INCLUDED)
1/4” FPT
Detail A: Install the pressure gauge. Hand tighten securely.
** DO NOT OVER-TIGHTEN **
Detail B: Screw the lid onto the tank. Place the end of the lanyard
through the tab in the tank. This is so the lid can ‘hang’ off
the tank when filling/rinsing the tank out.
Lanyard
Lanyard
Connection
Tab
DETAIL B
DETAIL C
DETAIL A
Detail C: Locate the (2) clips and (2) phillips head screws from the parts bag.
A phillips head screwdriver is required for this step
Place a screw through the hole in the clip and bring it up to the tank, where the emboss-
ments for the clips are (located on the rear side of the tank)
Secure the clip/screw to the tank. Tighten so that the clip is secure. Do this for each clip.
** DO NOT OVER-TIGHTEN **
The spray wand will snap into the clips once installed. Do not use excessive force when
placing the spray wand into the clips, as this could cause the clips to break.
Detail D: Locate the 48” feeder hose and attach to the manifold with a hose clamp.
Loosely slip a hose clamp over the end of the hose. Attach the hose to the hose barb on
the manifold. Use a twisting motion, if necessary, to get the hose fully onto the barb.
Bring the hose clamp to the connection point and tighten securely.
NOTE:
Make sure this boom feeder hose does not end up on the ‘outside’ of the spray wand
hose, otherwise unwrapping the spray wand hose from around the tank may be difficult.
DETAIL D
Step 3
*** The Sprayer should now be ready for use ***
Manifold
Connection
