10
INSTALLATION
2.4 Connecting the Display
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the DC plug to the power connector on the monitor and the other end into an
electrical outlet.
3. Connect the D-SUB or DVI cable from the display’s D-SUB or DVI input connector to the
D-SUB or DVI connector of your host computer and tighten the screws.
4. Connect the USB cable from the USB port of your display to the USB port of your computer.
5. Configure the touch screen. Refer to the “4.5 Touch Screen Driver Installation” section on
page 19.
6. Once the touch screen is configured, the monitor is ready for use.
!
Notice!
To ensure the LCD display works well with your computer, please configure the display mode
of your graphics card to make it less than or equal to 1920 x 1080 resolution and make sure
the timing of the display mode is compatible with the LCD display.
We have listed the compatible “Video Modes” of your LCD display in the appendix (on page
18) for your reference
.
External power supplies applicable: Lite-On/PA-1051-0
