27
USING THE LCD DISPLAY
3.4 Setting Up the IR Sensor
Before using the remote control, the IR sensor must be positioned correctly. The IR sensor is located on the
right side of the rear of the display as illustrated below.
To set up the IR sensor, do the following:
1
Remove the two screws securing the IR sensor to the LCD display and loosen the IR sensor.
2
Unthread the cables from the cable clip.
3
Attach the IR sensor to the desired position on the display using the magnets located on the sensor.
4
Point the remote control toward the display’s IR sensor within a distance of less than 3 m / 9.84 ft,
and a horizontal and vertical angle of less than 30 degrees, when operating the remote control.
Reverse steps 1 ~ 3 to return the sensor to its original position.
IR/ L ight
sensor
Magne ts
Note:
♦
Please make sure the light sensor is not covered when enabling Auto Dimming function.
