AG-BAG LX1214, Operator'S Manual

Page: 59 / 276

3 - CONTROLS AND INSTRUMENTS
Right side corner post controls
Ignition switch
The ignition switch (1) is located on the right side cab post.
Turn the key from the off (2) position, past the run (3)
position to the start (4) position to crank the engine. Once
the engine starts, release the key and it will return to the
run position.
Remove the key from the ignition switch whenever leaving
the vehicle unattended.
Turn the ignition switch to the accessory (5) position to op-
erate any switched accessories such as radios, etc. with-
out having the engine running.
RAIL16GEN0050AA
1
Parking brake
The parking brake control (1) is a pull to apply, push to
release control. It is located on the right side corner post
of the cab above the system pressure gauge
(2) and the
ignition switch (3) .
Pull the yellow control knob (1) out to apply the parking
brake. The parking brake is set with the absence of air
pressure.
Push the yellow control knob (1) in to release the parking
brake. The parking brake requires air pressure to release.
Always apply the parking brake before leaving the cab or
leaving the vehicle unattended.
When the parking brake is applied, the parking brake icon
(4) will be displayed until the parking brake is released.
RAIL16GEN0050AA
2
RAIL16GEN0051AA
3
System air pressure gauge
The system air pressure gauge is located on the right side
corner post next to the ignition switch and monitors the
pressure in the bagger air system.
RAIL16GEN0050AA
4
3-21