© Copyright LOTRONIC 2012 BAR-LED-412
Page 5
DMX mode address set
Power on, the screen shows “0—9”, the data is the DMX random address. When there is no DMX in, the light
would be blackout.
5 DMX channels for each light, (R.G.B, RGB Dimmer, strobe), Fox example, address 001 occupies the channel
1, 2, 3,4and 5. Address 508occupies the channel 508,509, 510,511 and 512.
Note: after finished adjusting, leave the key alone for 10 second to exit the programming, the digital
display stop flashing and memorize the selected parameters.
Master-slave
a) choose anyone light as the master unit
b) The Master is the light which is choose “P**”, others which choose “SLA” are the slaves.
Change function of the master light, then all lights will work synchronously.
DMX CHANNEL TABLE
DMX channel
DMX Value
Detailed functional
1
0 – 255
Red dimmer ( from 0 to 100% )
2
0 – 255
Green dimmer ( from 0 to 100% )
3
0 – 255
Blue dimmer ( from 0 to 100% )
4
0 – 255
RGB dimmer ( from 0 to 100% )
5
0 - 255
Strobe ( from slow to fast )
The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems
have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
CAUTION
: Disconnect from mains before starting maintenance operation!
Cleaning and Using Frequency of Product
Please make sure that the light is power off before dismantling or maintaining, it’s very important to keep the light
clean. Frequent cleaning will ensure maximum brightness output, but also prolong the life time. It’s suggested to use
the high quality, professional glass detergent and soft cloth to clean the light. It’s not allowed to use alcohol or
chemical solvent. The inner part of the light should be cleaned by vacuum cleaner at least once a year.
When the light doesn’t work, please check if the fuse is burnt out or not. If it is, the same fuse should be replaced,
find out the faulty and restart the light. But please note the repair must be handled by professional.
