©Copyright LOTRONIC 2015
9BEAM-FX
Page 5
fixture.
2. Connect the end of the cable coming from the
first fixture which will have a (female) 3 pin
connecter to the input connecter of the next fixture
consisting of a (male) 3 pin connecter. Then,
proceed to connect from the output as stated
above to the input of the following fixture and so
on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initialized
for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow may also
require a slave setting. Please consult the '' Operating Instructions» section in this manual for complete instructions
for this type of setup and configuration.
FUNCTION MENU
DMX Address
A001---A512
Channel Mode
12 ch, 43ch
Show Mode
Sound, Auto
Slave Mode
Master, Slave
Black Out
YES, NO
Sound State
ON, OFF
Sound Sense
0 –100 off – the most sensitive
Pan Inverse
YES, NO
Tilt1Inverse
YES, NO
Tilt2Inverse
YES, NO
Tilt3Inverse
YES, NO
Back Light
On, Off
Auto Test
Automatic test
Fixture Time
0----9999
Firmware Version
V104
Defaults
YES,NO
System Reset
YES,NO
Function Mode
DMX address setting
With this function, you can adjust the desired DMX-address via the Control Board.
1. Press the either the MENU, UP or DOWN buttons until
“ADDR”
is displayed, press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find your desir
ed
address. Press ENTER to set your desired DMX address.
Channel Mode
The unit has 12 or 43 channels that can receive the International DMX signal.
Show Mode
The user can select between
【
Sound
】
and
【
Auto
】
mode
