``
24
(Numbers refer to Figures 6 and 7)
Hazard button
(1.16)
The Hazard button activates the hazard lights (i.e., both indicators
and the front and rear blinkers). When the hazard lights are activated,
all three LEDs (5.3, 5.4, 5.6) flash.
To turn off the hazard lights, press the button again.
Lock-out while
charging
When
AFISCOOTER C
is being charged it is in lock-out mode. In this
mode it cannot be driven.
After stopping
After stopping
AFISCOOTER C
, turn the key switch (1.17) to OFF and
remove the key. The green LED will turn off.
Note:
The EMB locks automatically when the throttle control lever is
released and
AFISCOOTER C
has come to a complete stop.
Safe driving
When driving on ramps, high curbs and on sharp turns, drive very
slowly and carefully, preferably with the speed set to MIN.
When going up or down a step, always drive so that the wheels are
fully perpendicular to the step, and both of the rear wheels meet the
step at the same time.
Never try to go on an obstacle that is more than the maximum
recommended slope or curb height (see the stabilities and the
obstacle climbing specifications given in Appendix A
– Specification
Sheet)
Always drive carefully and adjust your speed to the road
conditions.
Before making sharp turns, reduce speed to minimum, to
prevent side roll-over.
Climbing an
obstacle
To climb an obstacle, drive
AFISCOOTER C
forward toward the
obstacle until the front wheel touches the obstacle, then, maintaining
your direction, increase speed.
Driving on slopes
and turns
Before making sharp turns, particularly on
inclines,
reduce speed to minimum, to prevent
side roll-over.
AFISCOOTER C
is able to go up slopes steeper
than the recommended safe slope.
Do not drive on including where you are not
sure about the degree of slope. Always drive
very slowly on inclines, and be sure not to
approach the incline side-on (fully forward
only).
Prior to use
After reading through this entire manual and before using the
AFISCOOTER C
, do a visual check of all the vehicle parts, to make sure
that there is no visible damage. If you have any questions or
concerns, contact your dealer.
Controller
programming
Several parameters of
AFISCOOTER C
controller can be programmed.
Programming must be done by a trained authorized technician only.
Incorrect programming can cause abnormal operation of the
AFISCOOTER C
and may result in damage and personal injury.
