CHANGING WIPING ANGLE
1.
Turn on and then turn off wiper switch and allow wiper to
move to parking position.
WARNING:
Wiper should automatically park (move to
one side or the other) after the wiper is turned off.
Failure to do so indicates that the wiper is incorrectly
wired. Review wiring diagram.
2.
Remove the wiper blade; remove wiper from its mounting
position.
3.
Remove the wiper motor cover mounting screws (Qty: 6)
using a Phillips head screwdriver.
AFI-1000 Angle Choices: 50, 65, 80, and 110 degrees
AFI-2000 Angle Choices: 45, 60, 80, and 110 degrees
4.
Remove the POSITION SCREW from the TRANSMISSION
PLATE. Remove the two (2) SWEEP ANGLE SCREWS.
NOTE: Make sure that the SHAFT PLATE keeps in position
as shown on drawings below. Do not allow wiper output
shaft to rotate 180 degrees out of position (proper position
shown on drawings). If wiper output shaft rotates out of
position shown on drawing, wiper motor failure will occur.
Rotate SWEEP ANGLE PLATE so that the desired angle
hole is in the “6 o’clock” position for right parking or the “12
o’clock” position for left parking (see drawings below).
Reinstall the two (2) SWEEP ANGLE SCREWS.
Reinstall the POSITION SCREW.
Be careful to securely re-tighten ALL SCREWS to prevent
accidental loosening (15 in-lbs. maximum).
5.
Reinstall wiper motor cover, taking care to snug the
mounting screws
without over tightening
. Be sure to
tighten screws evenly around cover. Gap between the cover
and base should be even all around.
6.
After remounting wiper motor, turn on motor and observe
operation prior to reinstalling wiper arm. Verify that wiper
rotates through the correct number of degrees and parks in
the correct position prior to installation of wiper blade.
Failure to do this could cause damage to wiper motor.
CHANGING PARKING POSITION
1.
Remove the wiper motor cover as described under the
section, “Changing The Wiping Angle.”
2.
Note the current sweep angle inscribed on the angle plate.
Remove the POSITION SCREW. Remove the two (2)
SWEEP ANGLE SCREWS.
3.
Rotate SWEEP ANGLE PLATE 180 degrees.
NOTE: Depending on original parking location (right or left),
the “position screw” will be either in the “6 o’clock” position
or the “12 o’clock” position. In order to reattach the
transmission plate to the original hole, you will need to move
the transmission plate to the other end of its travel (see
drawings below).
4.
Reinstall the two (2) SWEEP ANGLE SCREWS. Reinstall
the POSITION SCREW in the same sweep angle hole from
which it was removed.
NOTE: Installing the position screw in any other angle hole
will cause the parking position to be incorrect. If you wish to
make the sweep angle adjustment, see “Changing The
Wiping Angle” instructions.
5.
Reinstall wiper motor cover as described under the section
“Changing The Wiper Angle.”
