aFe Power SCORPION 79-21004L, Instruction Manual, Page: 34 / 36

33
PLEASE CONSULT YOUR LOCAL AUTOMOTIVE ELECTRICAL PROFESSIONAL FOR INSTALLATION SERVICES AND ADVICE. aFe Power
IS ONLY EQUIPPED TO PROVIDE BASIC TECHNICAL ASSISTANCE DUE TO THE DIVERSITY OF VEHICLES, VEHICLE OPTIONS &
MODIFICATIONS AND LIGHTING.
CONFIGURATION OPTIONS AVAILABLE. aFe Power products cannot be held liable due to improper component installation and /
or faulty wiring.
GENERAL GUIDELINES:
LED Lights & LED Light Bars operate at relatively high currents and should only be installed by qualified personnel with
experience in switched / relayed high draw DC Circuits.
- Light Bars are designed for use only with standard 12v DC power systems
- Light Bars are for OFF-ROAD USE ONLY. Check your local laws & regulations regarding vehicle mounted lights.
- Some Light Bars are equipped with waterproof connectors while others are simply pig-tailed
- Red Wires = POSITIVE | Black Wires = NEGATIVE
- ALWAYS install your lights on a fused circuit. Basic fusing guidelines: maximum 5A for every 10” of LED Light Bar.
GENERAL USE, INSTALL AND ADJUSMENT TIPS
NOTE 1: aFe Scorpion Grilles (with LED Light Bars installed), and LED Light Bars themselves are for OFF-ROAD USE ONLY.
NOTE 2: To adjust the angle of your light bars simply loosen the mounting hardware on either side of each Light Bar, rotate the
Light Bar to adjust the angle, then tighten the hardware once the desired angle is achieved (please be careful not to over-tighten
the mounting hardware or scratch the protective powder-coat finish). It is best to adjust the angle with the vehicle on level
ground with the lights facing a wall, garage door or other solid barrier at approximately 25-30 feet.
NOTE 3: Please consult a qualified automotive electrical professional for light bar wiring installation.